- 6 -
ASSEMBLY INSTRUCTIONS
1.
Attach the fold bars to the legs.
Parts: left and right pairs of legs
Hardware bag A: 4X fold bars, 4X 10-24 x 1-1/4" carriage bolts,
8X #8 SAE washers, 4X 10-24 lock nuts
NOTE: Wolf loom legs are called out by where they cross
each other. The legs that touch the ground at the front of
the loom are called “inside” legs because they are covered
by the “outside” legs when they cross at the loom center.
Lay the left pair of legs on the floor with the outside leg on top and
pointing to the right, as shown in Figure 1A. Orient the fold bars
as shown in Figure 1A, with round holes meeting between the
legs and the jogs in the bars pointing toward the floor—in other
words, the round holes should be closer to the floor than the
square holes.
On the left inside leg, identify the
first
hole above the bolt where
the legs meet. Insert a 10-24" x 1-1/4" carriage bolt through the
square hole of the fold bar, then through a #8 SAE washer, then
through the hole in the inside leg from above, then through
another #8 SAE washer. Secure the carriage bolt with a 10-24 lock
nut (Figure 1B); attach the lock nut just tightly enough to allow
the fold bar to rotate.
On the left outside leg, identify the
first
hole above the bolt where
the legs meet. Insert a 10-24 x 1-1/4" carriage bolt through the
square hole of the fold bar, then through a #8 SAE washer, then
through the hole in the outside leg from below, then through
another #8 SAE washer. Secure the carriage bolt with a 10-24 lock
nut (Figure 1B); attach the lock nut just tightly enough to allow
the fold bar to rotate.
Repeat this step for the right pair of legs, orienting them as
shown in Figure 1C. On the right inside leg, attach the fold bar
at the
first
hole above the bolt where the legs meet. On the right
outside leg, attach the fold bar at the
third
hole above the bolt
where the legs meet.
FIGURE 2: ATTACH CASTLE SIDES TO LEGS
left legs & left castle side
(inner side)
right legs & right castle side
(inner side)
insert bolt
through hole in
castle sides
2.
Attach the castle sides to the legs.
Parts: left and right castle sides
Hardware bag A: 2X 1/4" USS washers, 2X 5/16-18 lock nuts
Place one pair of legs on the floor so that the bolt shaft connecting
the legs points upwards. Orient the corresponding castle side
as shown in Figure 2. Put the bolt through the hole in the castle
side, place a 1/4" USS washer on the bolt, and secure with a 5/16"
lock nut. Attach the lock nut firmly, but not so tightly that the legs
cannot fold and unfold.
Repeat this step for the remaining pair of legs and castle side.
A
carriage bolt &
fold bar attached
from inner side
of leg
10-24 x 1-1/4"
carriage bolt
left outside leg
10-24
lock nut
#8 SAE
washers
left inside leg
B
10-24 x 1-1/4"
carriage bolt
fold bar, end with square hole
#8 SAE washer
10-24
lock nut
#8 SAE washer
leg
FIGURE 1: ATTACH FOLD BARS TO LEGS
C
right inside
leg
right outside
leg
