- 15 -
24.
Install the beater pin.
Hardware Bag G: 1X beater pin and chain, 1X beater pin holder,
1X #6 x 5/8" Phillips pan head screw
Insert the #6 x 5/8" Phillips pan head sheet metal screw through
the hole in the end of the beater pin chain and through the hole
in the beater pin holder (Figure 24A). Fasten the screw into the
small pilot hole in the outside right leg (Figure 24B).
The beater pin holds the beater upright during warping. Hold the
beater upright so the slot in its side aligns with the hole above the
beater pin holder. Push the beater pin through this hole and into
the slot in the beater side (Figure 24C).
23.
Install the removable back beam.
Parts: back beam
Hardware Bag G: 2X 1/4-20 barrel nuts, 2X 1/4" fender washers,
2X back beam knobs
Slide the back beam into the slots cut in the top of the inside legs.
Insert a 1/4-20 barrel nut into the holes on each end of the back
beam.
Place a 1/4" fender washer on a back beam knob and insert the
knob through the leg, into the back beam. Tighten the knob into
the barrel nut (Figure 23). Repeat for the other end of the back
beam.
FIGURE 24: INSTALL THE BEATER PIN HOLDER
slot in right
beater side
hole in outside
right leg
C
A
beater pin
beater pin
chain
beater pin
holder
#6 x 5/8" Phillips pan
head sheet metal screw
B
hole for using
beater pin
hole for beater
pin holder
outside
right leg
slot in right
beater side
FIGURE 23: INSTALL THE REMOVABLE BACK BEAM
1/4" fender washer
back beam knob
1/4-20
barrel nut
back beam
