- 13 -
18.
Install the brake barrel nut.
Hardware Bag F: 1X brake barrel nut, 1X 1/4-20 x 1" Phillips pan
head machine screw
Place the brake barrel nut in the groove on the inner side of the
right inside leg. From the outer side of the right inside leg, insert
the 1" Phillips pan head machine screw into the brake barrel nut
and fasten securely (Figure 19).
FIGURE 18: INSTALL THE BRAKE BARREL NUT
brake barrel nut
1/4-20 x 1"
Phillips pan head
machine screw
right inside leg
(inner side)
19.
Install the brake bar and brake cable.
Hardware Bag F: 1X brake bar and cable, 2X 1/4" USS washers,
1X 5/16-18 slim lock nut
Remove all packing material from the pre-installed screw on the
inside right leg, just above the roll pin (Figure 19A). Place the
brake bar and a 1/4" USS washer on this screw, orienting the
brake bar and cable as shown in Figure 19B.
Take the loose end of the brake cable and wrap it under and
around the brake hub three times. Start next to the loom leg and
wrap with loops moving towards the loom center, making sure not
to overlap the cable (Figure 19C). Place the loop end of the cable
on the pre-installed screw over the brake bar and place a 1/4"
USS washer over the cable. Secure everything with a 5/16-20 slim
lock nut (Figure 19C). Make sure that the brake bar can pivot
freely—if it does not, slightly loosen the lock nut.
FIGURE 19: INSTALL BRAKE BAR AND BRAKE CABLE
B
brake bar &
1/4" USS washer
on screw
brake
cable
A
pre-installed screw
with packing material
roll pin
C
brake hub &
brake cable
loop end of brake cable,
1/4" USS washer,
5/16-20 slim lock nut
