ISD8001: Industrial ScentDirect
Diffusion System
Wall Mount Instructions
ISD-8001 TROUBLESHOOTING GUIDE
Problem
Solution
Unit display will not turn
on
Make sure unit is plugged in
Check for power to outlet
Verify MASTER POWER is in the
“ON”
position
Verify MODE is in the
“TIMER”
position
Cannot smell scent
Verify fan is operating by moving the MASTER POWER
Switch to “ON” rotating the FAN POWER knob to “MAX”
, listen
and feel for fan.
Verify pump is running. Set MODE Switch to “24
Hour”
. INTERVAL Switches should be set to 15/15.
FRAGRANCE INTENSITY KNOB should be rotated to “MAX”.
Pump should run, reduce INTENSITY KNOB until correct level is
reached.
Remove output tube and visually verify that vapor
exiting the collector.
Check bottle fill level,
verify oil in the container.
Reset interval switches by moving them between
settings and the on and off switch to one way and then the
other to ensure correct positioning
Verify that there is no obstruction in the pick-up tube
filter. Remove any debris on the pick up filter.
Pump does not run
Unplug unit from AC power, allow several seconds
then plug back in.
If pump stops immediately after restarting, there may
be a clog in the pressure line. Disconnect input tubing from
collector and restart pump. If pump runs, there is a clog in the
collector.
Power to unit
interrupted then
restored before a timed
event starts or after a
timed event ends.
Units plugged in before a timed event will run in the
ON mode, through the ON start time and should stop at the
designated OFF time.
Power interrupted then
restored after a timed
event has started
-OR-
MASTER POWER is
switched on after a
timed event has started
Units should start immediately and run in the ON
mode until the designated OFF time.
For further assistance please contact Technical Services at:
Phone # 704-504-2320 E-mail: [email protected]
