Wind cup
(replaceable)
Battery cap
(O-ring sealed)
Aluminum
sensor body
Wind cup
(replaceable)
Aluminum
sensor body
Power
When the “Lo battery” appears on the display, replace the sensor battery. Take off the battery cover (on the
bottom) by turning it counterclockwise. Pull out the battery holder and insert new battery (Lithium 3.6 V AA).
Range
The connection between sensor and receiver goes through free 868 MHz band (optionally 908MHz).
Transmission range is up to 500 meters (1300 meters at models XB) - at 10 m sensor mounting height and
when there is no obstacle between the sensor and the display unit. The range is much shorter inside
buildings. Normally the signal can be received through two to three walls.
Address
The correspondent sensor address has been present at the factory. Always set the address to correspond to
the address of the sensor from which the receiver will receive data. Address of the sensor is indicated on the
sensor label and in the interior of the sensor battery compartment.
Sensor unit switches ON automatically when the anemometer cups revolve. It switches OFF 6 hours after
the anemometer cups stop revolving. In ON state, the sensor updates wind speed data every two seconds.
Sensor
wind vane
Sensor & Receiver