Installing i-on Control Units
Page 31
i-on30R+/40H+ Installation Instructions
During installation, please refer to Figure 9 and to
Overview of PCB links, connectors and
on page 40.
Figure 9. i-on30R+ and i-on40H+: Control unit PCB
Step 1: Install cables
Use only the dedicated cable-entry holes, as shown in Figure 10.
For an i-on30R+, make sure mains cables are routed away from the internal aerials, as
shown in Figure 11.
Figure 10. i-on30R+ and i-on40H+: Fixing holes and cable entries
k
Kick-start link
Connect transformer
n
RS485 bus termination
Connect battery lead
Output
device
Bus device 1
(e.g. keypad)
e
Bus devices
(20 max)
c
Engineer keypad port
j
Network
port
f
Open-
collector outputs
For engineering use only
g
Loudspeaker
m
Auxiliary tamper
h
Siren/strobe unit.
Note:
If
a wired siren/strobe unit is
not fitted, connect TR to 0V.
a
SD card slot
b
Reset codes link
i
Zones 0 to 9
(i-o40H+ only)
l
Plug-on
module socket
d
Plug-by communicator ports
(i-o40H+ only)
o
HB LED
o
3V3 LED
o
LNK/ACT LED
f
Relay outputs
(i-on40H+ only)
0V/12Vdc
outputs
Connect tamper
switch
i-on40H+
or
i-on 30R+
Fixing holes
Mains cable entry
PCB
Fixing holes
Signal cable entry
Mains terminals