2
1 Transport & handling
1.1 Transport
Scantool SC 250 T industrial double-ended grinding machine is delivered on a pallet wrapped in
protective covering.
1.2 Handling
Scantool SC 250 T industrial grinding machine can easily be transported in the packing in which it is
delivered. If the grinding machine is delivered on a pedestal you must make sure that the pedestal is
secured to the transport pallet.
1.3 Placing
Placing of the industrial grinding machine must take place on a firm and level surface. Now tighten the
grinding machine to the floor or the working table by using the four bolt holes used for securing the
machine to the pallet.
The electrical voltage must be within the given ranges shown on the motor label.
The machine must be wired according to the wiring diagram (
please see section
5.3).
The wiring must be performed by an authorised installer. Please make sure that the motor has the
correct direction of rotation (please see the arrow on the cover).
Fig.: 1.1
Before operating the machine please control that the outer cover (A) (see
fig.: 1.1
) is secured to the inner
cover. The outer cover must be mounted during use of the machine and can only be dismounted during
maintenance. The grinding wheel (B) must be able to rotate freely without being loose. The tool rest (C)
must be adjusted to a distance of appr. 2mm from the grinding wheel.
The eye shield (D) must be kept clean and adjusted to the correct position and the spark arrester (E)
must also be adjusted to a distance of 5mm from the grinding wheel and lightly fastened.
All these checks and adjustments can only be made while the machine is disconnected from the power
source.
First time you start up the machine please let it run at maximum speed for appr. 5 minutes before start
grinding. Make sure you are positioned in a safe distance while doing the running test.
Summary of Contents for SC 250 T
Page 16: ...14 5 5...
