COMPACT 110
COMPACT 110
Operator’s manual for drilling machine
- 5 -
19. Tools must be fastened firmly. When a milling cutter is used, check before start of
work if tool holding screws are screwed tight.
20. It is not permitted to use blunt of damaged tools.
21. Do not use milling cutter without pilots, and arbors without ejection spring.
22. Use tools recommended in Operator’s Manual only.
23. After use always clean drilling machine from metal chips and coolant.
24. Always unplug machine from power supply during any work on the machine.
25. In the case that the machine falls on a hard surface, from a height, is wet or is
subjected to other unfortunate events that could affect its technical state - work
should be terminated immediately and the machine should be sent to service for
inspection as soon as possible.
It is not allowed to use drill on steel thinner than (less than 3/8”
(10 mm)). On thin steel (less than 3/8” (10 mm)) magnet’s adhesive power
would be significantly reduced what can cause machines failure or
individuals injury. The machine should be located on the work piece with
the entire surface of the electromagnetic base! It is recommended that each
time, before positioning the machine surface under the electromagnetic
base should be sanded down with abrasive paper!
Thickness lower than 5mm: Magnetic drilling machine COMPACT 110
won’t start because of CLAMPING FORCE CONTROL SYSTEM (see point 2.6).
Warning!
Read and save all instruction for future reference!
II. OPERATING INSTRUCTIONS
1. Cutters and optional equipment features
