18
7. Cut is binding blade
7. Decrease reed anti speed
Bad Cuts (Crooked)
1. Feed pressure too great.
2. Guide bearings not adjusted
properly
3. Inadequate blade tension.
4. Dull blade.
5. Speed incorrect.
6. Blade guides spaced out too much
7. Blade guide assembly loose
8. Blade truck too far away from wheel
flanges
1. Reduce pressure by increasing
spring tension on side of saw
2. Adjust guide bearing, the
clearance can not greater than
0.001.
3. Increase blade tension by adjust
blade tension
4. Replace blade
5. Adjust speed
6. Adjust guide space.
7. Tighten
8. Re-track blade according to
operating instructions.
Bad Cuts (Rough)
1. Too much speed or feed
2. Blade is too coarse
3. Blade tension loose
1. Decrease speed or feed.
2. Replace with finer blade.
3. Adjust blade tension.
Blade is twisting
1. Cut is binding blade.
2. Too much blade tension
1. Decrease reed pressure.
2. Decrease blade tension.
Saw arm can not
be raised up after
pushing the raising
button
1.Improper setting of depth gauge
1. Press the emergency stop
Button and RESET.
2. Check the upper limit switch
and stop round
Position. Make sure the limit
switch is always underneath the
stop round bar.
3. Check the oil gauge ; make
sure the oil is in proper range.
4. Check the motor revolution
direction; make sure the motor
revolution is in
clock-wise direction.
