MT8-COM3/RZC004850
5
9
1
6
1
5
6
9
1
5
6
9
5
9
1
6
2.3.5 Dip Switch
SW1
SW2 SW3 SW4 Mode
ON
OFF OFF OFF Touch Screen Calibrate mode
OFF
ON OFF OFF Reserve
OFF
OFF ON
OFF Boot Loader mode
OFF
OFF OFF ON Reserve
OFF
OFF OFF OFF Normal
z
Touch Screen Calibrate and Reset Password mode: In
this mode when you power on the MT-8000/6000, the
screen will display a “+” sign at the center of the screen.
Use a stylus or finger to push the center of the “+” until
it moves. The “+” moves to upper-left, upper-right,
lower -left, lower-right and center. When all five “+” are
done the “+” will disappear. The Touch Screen
parameter will store at Flash Rom.
z
If losing or forgetting system passwords, users can set
Dip Switch 1 to “ON” position, the rest of Dips remain
on “OFF” position and then reboot
MT-8000/6000.Under this situation, MT-8000/6000 will
jump to Touch Adjust (Touch screen calibration) mode.
After calibration, the pop-up window appears as the
illustration below. Users will be inquired if restoring the
system password to the default value.
z
When “YES” is chosen, another pop-up dialog appears
as below. Users will be confirmed again if restoring the
system password to the default value and will be asked
to input “YES”. Then click OK. (The default password
is 111111. However, other passwords, including
download and upload password, have to be reset.)
Note: When the reset action is be taken, projects and saved data in the HMI will all be cleared.
6
