SCANMASKIN SCAN COMBIFLEX 650, Manual

Page: 52 / 78

2.8 Safety regarding maintenance
Set the machine into the Safety off position before beginning any work on the machine.
See “2.7Definition of the “Safety off position””.
Never work on the machine while power is still connected! All parts must have come to a com-
plete stop before beginning any work!
When the machine is lying down on its back it might tilt to it’s upwards position. Take extra
care to prevent this from happening to ensure that no injuries or damages occur.
When the machine has been operated the segments, Scan-On plates and other parts on the
gear barrel may be hot. Take extra care to prevent burn injuries.
Adjustment, servicing and inspection work on the period of time limits, specified in this User
Guide as well as any information on the replacement or parts and equipment must be under-
taken and/or complied with!
These activities may only be undertaken by qualified personnel.
The machine must not be connected to any power source while cleaning.
See “2.7Definition of the “Safety off position”” for further information.
2.9 Safety regarding transport
Always remove the tools before transport. The tools may fall of or damage the surface the
machine is transported along.
2.9.1 Manual transport
When transporting the machine manually be observant about ramps and/or edges.
Follow local traffic regulations for the work site to prevent accidents. Failure to comply with
these regulations may cause injuries or damages.
2.9.2 Lifting
The machine must be secured according to local safety regulations before lifted.
No person is allowed beneath a lifted machine! The machine must be lifted according to
the instructions in “3.3Lifting”Observe the machines point of balance before lifting! Failure
to comply with these regulations may cause injuries or damages. Only use straps approved for the
weight and circumstances!
52
www.scanmaskin.com