SCANMASKIN SCAN COMBIFLEX 650, Manual

Page: 56 / 78

4.5 Start up
See ”4.1Precautions” before starting the machine.
How to start the machine
 Make sure that the power plug and hoses for dust collector and water (if used) are con-
nected to the machine.

Turn on the dust collector if used.

Push the handle downwards to lift the gear barrel about 10 cm (4”) from the ground.

Make sure that the “EMERGENCY STOP” button (3) is in its upper position. If not, release
it by turning it clock wise until it rises and press the “STOP” (5) button once to reset.

Press the “START” (4) button.

Lower the gear barrel down to the floor.
4.6 Stop
How to stop the machine
 Press the “STOP” (5) button.

Wait for the machine to come to a complete stop before letting go of the handle.

Turn off the dust collector if used.
4.7 Adjusting grinding speed
Turn the “SPEED” knob (6) clock wise to increase the grinding speed and counter clock wise to
decrease it. See “1.2Mechanical specifications” for the rotation speed range.
4.8 Change grinding direction
Use the “L/R” switch (1) to select grinding direction. The machine will automatically come to a
complete stop and restart in the selected direction.
4.9 Safety off position
When working on the machine, either maintenance or tool change, the machine must be set to
the “Safety off position”. See “2.7Definition of the “Safety off position”” for further information.
4.10 Grinding
Refer to “Grinding guide” for instructions and information about grinding.
56
www.scanmaskin.com