SCANMASKIN Ferox 300, Manual

Page: 36 / 50

36
www.scanmaskin.com
6.7, is screwed to this part. Wear & tear happens mainly to this part if it is in contact with the fl oor.
As previously mentioned, it is important to check all parts regularly. In doing so, it is not necessary
to unscrew the magnetic frame, just place the machine carefully on its side and check for wear &
tear.
6.9 Bearings
Bearings are always tricky in mechanical engineering. To change bearings is generally simple if
the rules are observed. However, for the purpose of this manual, too complex to describe in any
detail. If you have any doubts always refer to trained or experienced engineer.
The bearings for the Ferox 300 shot blaster, are situated in the motors, the drive unit lever, the
turbine axle housing, the drive unit frame and the wheels. Never attempt to change the motor
bearings by yourself. Return the motors to Scanmaskin or take them to a reputable motor rewind
technician
The turbine axle housing is the most diffi cult item to deal with. The bearings inside are under
the greatest stress from the operation of the machine. The lifetime of such high speed revolving
bearings is between 500 and 1000 hours. To change the bearings send the machine or machine
housing to Scanmaskin.