Levelling the unit
To do this adjust the two levelling feet at
front of the unit.
If the unit is not level, the doors and magnetic
seal alignments will not be covered properly.
Placement
Install this appliance at a location where the
ambient temperature corresponds to the cli-
mate class indicated on the rating plate of the
appliance:
For refrigerating appliances with climate
class:
-
extended temperate: ‘this refrigerating
appliance is intended to be used at ambi-
ent temperatures ranging from 10°C to
32°C (SN);
-
temperate: ‘this refrigerating appliance is
intended to be used at ambient tempera-
tures ranging from 16°C to 32°C (N);
-
subtropical: ‘this refrigerating appliance
is intended to be used at ambient tem-
peratures ranging from 16°C to 38°C (ST);
-
tropical: ‘this refrigerating appliance is in-
tended to be used at ambient tempera-
tures ranging from 16°C to 43°C (T);
Location
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can cir-
culate freely around the back of the cabinet.
To ensure best performance, if the appliance
is positioned below an overhanging wall unit,
the minimum distance between the top of
the cabinet and the wall unit must be at least
50 mm. Ideally, however, the appliance
should not be positioned below overhanging
wall units. Accurate leveling is ensured by
one or more adjustable feet at the base of the
cabinet.
This refrigerating appliance is not intended to
be used as a built-in appliance.
Warning! It must be possible to disconnect
the appliance from the mains power supply;
the plug must therefore be easily accessible
after installation.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate cor-
respond to your domestic power supply. The
appliance must be earthed. The power supply
cable plug is provided with a contact for this
purpose. If the domestic power supply socket
is not earthed, connect the appliance to a
separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if
the above safety precautions are not ob-
served.
This appliance complies with the E.E.C. Direc-
tives.
First use
Cleaning the interior
Before using the appliance for the first time,
wash the interior and all internal accessor es
with lukewarm water and some neutral soap
so as to remove the typical smell of a brand-
new product, then dry thoroughly.
Important! Do not use detergents or abrasive
powders, as these will damage the finish.
