Scandomestic SKF 500, User Manual

Page: 17 / 19

17
Maintenance
This production has automatic defrosting function, without
manual operation.
Precautions for internal and external cleaning of refrigerator:
• Before cleaning, always turn off the power switch, discon-
nect the power plug.
• During cleaning, make sure that no water will enter the
switch, control panel, door lamp and top control box.
• Remove dirt from the outside of refrigerator with mild
cleaner, then wipe with clean soft cloth, and let the refrig-
erator dry naturally.
• When cleaning door sealing strip, always use clean water,
wipe with dry cloth and let it dry naturally. Wet soft cloth
with warm water or neutral cleaner to wipe the refrigerator
body except the door sealing strip.
• It is forbidden to flush the refrigerator directly with water,
which will affect electrical insulation properties, etc.
• It is forbidden to clean the refrigerator with metal wipers,
ware brushes, coarse abrasive cleaners, strong alkaline
detergents, or flammable or toxic cleaning fluids.
After cleaning, connect the power plug of refrigerator, and con-
nected with the refrigerator.
On vacation
• When you want to leave for vacation, you had better to
make the refrigerator operate continuously and leave foods
that can be stored for a short time. If you want to stop the
refrigerator, remove all foods, disconnect the power plug,
clean the inside of refrigerator fully, and open the door to
avoid producing abnormal odors.
At power failure
• Generally, short-term power failure will not affect the tem-
perature of the refrigerator sharply. However, if power failure
lasts for a long time, you shall reduce the opening frequency
of refrigerator, and shall not put fresh foods into the refrig-
erator (prevent rise in the temperature of refrigerator from
speeding up).
• If you know power failure is coming, you can turn on
the “Super Frz.” function in advance to keep the temperature of
refrigerator to the lowest value.
Shutdown
• Generally, it is not suggested to stop refrigerator or turn off
the power switch; otherwise, the life of refrigerator may be
affected.
Normal phenomena
Button failure
Please check the control board whether the fridge under lock
mode.When under lock mode, all buttons can’t work.
Low voltage, the compressor can’t start
You should purchase pressurizer of more than 1000W when the
area of the appliance installation, that’s better to protect your
fridge.
Long time to start
When the ambient temperature too high, it will take long time
to start the appliance.
Middle beams feel hot
Middle beams feel hot after a period of time of the appliance run,
it belongs to the normal phenomenon.
Dew drops
When external air flows into the cool inner surface of the fridge,
dew drops can be formed.
If the humidity of the installed location is high or during the rainy
season, dew drops can form on the outer side of the fridge.This
is a natural phenomenon that occurs during the humid weather,
Wipe the water drops with a dry cloth.
Noise
When you operate the fridge for the first time, the fridge will op-
erate at high speed to cool fast and the sound can seem louder.
When the internal temperature falls below a certain level, the
noise will subside.
When the operation of the compressor is starting or ending;various
parts expanding/contracting or various control devices operat-
ing or temperature change within the fridge, you will hear the
sounds, these are normal sounds.
Compressor hot
When working, the temperature of the compressor outer is more
than 80°C, please do not touch the compressor, it may cuase
serious injury.
Compressor long time running
When the ambient temperature too high or put too much fresh
foods into the fridge, it will take long time to cool down until the
appliance run at the setting temperature.