12
Never unplug the refrigerator by pulling the power cord. Always
grip the plug firmly and pull straight out from the receptacle.
Do not use an extension cord with this appliance. If the power
cord is too short, have a qualified electrician or service technician
install an outlet near the appliance. Use of an extension cord can
negatively affect the performance of the unit.
Prepare with requirements
Installation Location
When selecting a position for your Fridge/Freezer you should
make sure the floor is flat and firm, and the room is well venti-
lated. Avoid locating your Fridge/Freezer near a heat source, eg.
cooker, boiler or radiator.Also avoid direct sunlight in out-
buildings or sun lounges. If you are placing your Fridge/Freezer in
an out-building such as a garage or annex ensure that the
Fridge/Freezer is placed above the damp course, otherwise con-
densation will occur on the Fridge/Freezer cabinet. Never place
the Fridge/Freezer in a wall recess or into fitted cabinets or furni-
ture. When your Fridge/Freezer is working, the grille at the back
may become hot and the sides warm. Therefore, the back part of
the refrigerator / freezer must be installed at least 30mm of free
space, both sides should be left more than 300mm. Do not drape
the Fridge/Freezer with any covering.
Dimensions in mm
W703 - D703 - H1850 - A1350 - B1350 - C125 - E30 - F300
Leveling the Fridge/Freezer
If the Fridge/Freezer is not level, the door and magnetic seal
alignment will be affected and may cause you Fridge/Freezer to
work incorrectly. Once the Fridge/Freezer is placed in its final lo-
cation, adjust the leveling feet at the front by turning them.
Cleaning before use
Wipe the inside of the Freezer with a weak solution of bicar-
bonate of soda. Then rinse with warm water using a damp
sponge or cloth. Wash the baskets and shelves in warm soapy
water and dry completely before replacing in the Freezer. The
external parts of the Freezer can be cleaned with wax polish. See
page 9 for more details on cleaning.
Before plugging in YOUMUST
Check that you have a socket which is compatible with the plug
supplied with the Freezer. If not see the section called
ELECTRICAL INFORMATION on page 11.
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER MOVING THE
FREEZER.
The coolant fluid needs time to settle. If the appliance is
switched off at any time, wait 30 minutes before switching back
on to allow the coolant fluid to settle.
Before filling your Freezer
Before storing foods in your Freezer, turn the Freezer on and
wait for 24 hours, to make sure it is working properly and to al-
low the Freezer to fail to the correct temperature. See page 5 for
more details.
INTRODUCTION
Before use
Please read these instructions and the Safety guidelines on page
1 carefully before using your new Fridge/Freezer. The
Fridge/Freezer is for indoor, domestic use only.
No
Description
1
Lighting switch
2
Cooling room shelves
3
Light
4
Vegetable and fruit crisper
5
Vegetable and fruit crisper cover
6
Freezing drawers
7
Door balcony
