![background image](http://html1.mh-extra.com/html/scag-power-equipment/stc52v-25cv/stc52v-25cv_operators-manual_1205869040.webp)
36
R
Section 7
Secure the cutter blades to prevent them from
3.
rotating, (use the optional Blade Buddy tool P/N
9212, to assist in securing the cutter blades), remove
the nut from the blade attaching bolt. Remove the
cutter blade, bolt and spacer from the spindle shaft.
See Figure 7-8.
- Note -
The front of the machine will have to be raised
slightly to remove the blade bolt from the cutter
spindle.
To install the new cutter blade, put the flat washer
4.
onto the blade bolt and slide the bolt into the hole in
the cutter blade.
WASHER
HEX HEAD BOLT
CUTTER
BLADE
SPINDLE
ASSEMBLY
CUTTER BLADE
SPACER
HEX HEAD
BOLT / NUT
CUTTER
DECK
SPINDLE
SHAFT
HEX NUT-TORQUE
TO 75 LB-FT
Blade Replacement
Figure 7-8.
- Note -
Be sure that the blade is installed with the lift wing
toward the top.
Install the spacer onto the blade bolt and insert the
5.
bolt into the cutter spindle shaft.
Install the hex nut to the blade bolt at the top of the
6.
cutter spindle. Secure the blades from rotating and
torque to 75 ft/lbs. See Figure 7-8.
TIRES
7.10
Check the tire pressures after every 8 hours of operation
or daily.
Caster Wheels
25 PSI
Drive Wheels
12 PSI
BODY, DECk, AND UPHOLSTERY
7.11
CAUTION
Do not wash any portion of the equipment while it
is hot. Do not wash the engine; use compressed
air.
After each use, wash the mower and cutter deck.
1.
Use cold water and automotive cleaners. Do not use
pressure cleaners.
Do not spray electrical components.
2.
Use a mild soap solution or a vinyl/rubber cleaner to
3.
clean the seat.
Repair damaged metal surfaces using Scag touch-
4.
up paint available from your authorized Scag dealer.
Wax the mower for maximum paint protection.