Scag Power Equipment MODEL TS, Operator'S Manual

Page: 5 / 14

3
3. Attach the mounting brackets to the cross bar
between the wheel motor brackets using (4) u-
bolts and (8) serrated flange nuts. See Figure
3-1. Do not tighten the hardware.
-NOTE-
If the Tiger Striper is installed on an STT with
a serial number below 7219999, part
number 423966 mounting spacer will need to
be installed between the mounting bracket
and cross bar. See Figure 3-1.
FIGURE 3-1
4. The edge of the mounting bracket should be
under the wheel motor mounting plate for proper
installation. See Figure 3-1.
5. Install the left and right hand Striper Stop
Brackets (p/n 423953 & p/n 423954) to the
frame and secure with (4) 3/8-16 x 1" bolts and
(4) elastic stop nuts. See Figure 3-2.
FIGURE 3-2
6. Install the Tiger Striper roller assembly to the
mounting brackets and secure with the quick
pins.
7. Once the Tiger Striper roller assembly is installed
and secure, tighten the mounting hardware on
both mounting brackets.
8. Follow Section 2.2 Operating Instruction for
proper operation.
3.2 ASSEMBLY INSTRUCTIONS - STC
-NOTE-
Use the illustrated parts list as a part
number reference when following the
assembly instructions.
1. Remove all packaging materials. Lay out the
mounting hardware and the Tiger Striper
assembly for easy access.
2. Prepare the machine so there is easy and safe
access to the work area. Remove the key and
maintain all safety related work procedures.
Always wear eye and hand protection.
423953 L.H.
Stop Bracket
423954 R.H.
Stop Bracket
(4) 3/8-16 x 1" Bolt
(4) 3/8-16 Elastic
Stop Nut
STT with a serial number of 7219999 or Below
(4x) U-Bolts
(8x) Serrated Flange
Nuts
(4x) U-Bolts
(8x) Serrated Flange
Nuts
Mounting
Bracket
Mounting
Bracket
Mounting
Spacer
Mounting
Spacer
Mounting
Bracket
Mounting
Bracket