13
R
Section 4
Hourmeter (Figure 4-1).
6.
Indicates the number of
hours the engine has been operated. It only operates
when the engine is running. Has preset maintenance
reminders for engine and hydraulic system oil
changes. Will start flashing scheduled maintenance
2 hours before preset time and continue flashing
until 2 hours after. Automatically resets.
Fuse Holders (Figure 4-1).
7.
Two 20-amp fuses
protect the mower’s electrical system. To replace
fuses, pull fuse out of the socket and install a new
fuse.
Left Steering Control (Figure 4-1).
8.
Used to control
the mower's left wheel when traveling forward or
reverse.
Right Steering Control (Figure 4-1).
9.
Used to
control the mower's right wheel when traveling
forward or reverse.
Brake Pedal (Figure 4-1).
10.
Depressing the brake
pedal applies the brake.
Parking Brake Lock Latch (Figure 4-1).
11.
Used
to lock the parking brake in the engaged position.
Fully depress the brake pedal and pull the parking
brake lock latch back to lock the parking brake in the
engaged position. See Figure 4-2. Fully depress the
brake pedal forward to disengage the parking brake
lock latch, then release the brake pedal to disengage
the brake. See Figure 4-3.
PUSH BRAKE
PEDAL FORWARD
PULL BACK ON
PARKING BRAKE
LATCH
engaging Parking Brake
Figure 4-2.
PUSH BRAKE PEDAL
FORWARD THEN RELEASE
PEDAL TO DISENGAGE
Releasing the Parking Brake
Figure 4-3.
Fuel Tank Gauge (Figure 4-1).
12.
Indicates the
amount of fuel in the fuel tank.
Dump valve Control Levers (Figure 4-1).
13.
Located
on the left and right side of the machine, used to
“free-wheel” the mower. Move the levers forward until
they stop allows the unit to move under hydraulic
power. Move the levers back and towards the engine
allows the mower to be moved by hand (free-
wheeling). See Figure 4-4.
DUMP VALVE
CONTROL LEVER
"FREEWHEEL" POSITION
2012 SCZ48 52 DVL
DUMP VALVE
CONTROL LEVER
"FREEWHEEL" POSITION
Dump Valve Control
Figure 4-4.
Deck Lift Foot Lever (Figure 4-1).
14.
Used to raise
and lower the cutter deck. Push full forward to lock in
the transport position.
Cutting Height Adjustment (Figure 4-1).
15.
Used to
set the cutter deck at the desired cutting height.
Deck Release Lever (Figure 4-1).
16.
Used to lock the
cutter deck in the transport position. Push the foot
pedal forward and pull back on the release lever to
release the cutter deck for normal mowing.
