Customer Helpline
1300 889 028
7
NOTE: Before using the tool, read the instruction book carefully.
Caution!
●
Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
●
Dirt in the feed water will damage the unit. To avoid this risk, we recommended
checking the water filter (20) (located inside the water inlet; to clean it out see
maintenance section).
●
Always prevent debris from being drawn into the unit by using a clean water source
and an water filter (20) if required.
Water supply (cold water only)
1. Do not draw non-water liquids through the unit. For use with cold water supply only.
2. Water hose must be at least a 1/2” in diameter.
3. Flow rate of water supply must not fall below 6 l /min.
4. Flow rate can be determined by running the water for one minute into an empty
container.
5. The water supply temperature must not exceed 60
o
C (140
o
F).
ASSEMBLY
1. ASSEMBLING SPRAY GUN HOLDER
Press the spray gun and lance holder (2) on to the machine. (See A1)
2. MOUNTING OF HOLDER FOR ELECTRIC CABLE
Press the cable holder (15) on to the machine. (See A2)
3. MOUNTING OF HANDLE
Press the handle (3) on to the machine, and fix the six screws. (See A2)
6
6
A
C
B
8
9
20
A1
A2
B2
B1
C2
C1
D2
D1
F
E
G2
G1
C4
C3
H2
H1
Assembly
