10
/
11
INSTRUCTION MANUAL JUMP STARTER SC POWER SC15
Power on the Mini Jump Starter. To energize the output manually, hold the Jump Start and Weak Battery Jump Start
simultaneously for 3 seconds. The Jump Start light is flashing and the clamps will be live in this condition.
Please make
sure the polarity is properly connected before these 2 buttons are pressed, otherwise the device
will be severely damaged.
Turn the vehicle’s starter over until the engine starts, the device will turn off after
cranking for 4 seconds. If the vehicle has not started within this time,
wait for 15 seconds and repeat again. (Maximum 5
cranking attempts are recommended, otherwise the device might be damaged.)
ATTENTION:
1. Once the car engine has successfully started, please press the power button to turn off the device A.S.A.P.
2. The device will automatically shut down when idled for 2 minutes.
3. Always re-charge the device after use or have it fully re-charged before use.
4. Even though the device has a protection, please avoid trying to crank an engine exceeding its capability.
5. In case the operation on a car with a weak battery has failed and Jump Start red light is flashing, the car battery is
short circuiting or dead. Please replace the battery as soon as possible or get in contact with a professional engineer
to examine the car.
SIDE LIGHT
Press SIDE LIGHT BUTTON to turn it on. The light must be turned off after use, otherwise the battery power will be
depleted.
