Saykey Key-fob, User Manual

Page: 5 / 8

‐ 5 ‐
[Note:] Keyfob exits setting mode in 30 seconds after press and hold both and key together for 2 seconds enter it
without any following action.
„
Add Z ‐ Wave Device into key ‐ fob
1) Press and hold both and key together for 2 seconds until LED indicator light on, release all key;
2) Press and hold key for 2 seconds until LED indicator flash slowly (3 second on, 3 second off), key ‐ fob starts add
device processing;
3) Refer to device manual, trigger the device which is going to included start network add/remove mode;
4) If key ‐ fob detects any device started network add/remove mode, it implement add device procedure and LED indicator
light on for 3 seconds after inclusion successful; If key ‐ fob has not detects any device in 60 seconds, exit add device
process and LED indicator goes off.
[Note:] Key ‐ fob associate the included device to all association control groups (#2~#4) automatically after add a new device. Then,
user can press On/Off/Stop key control all included devices(Group #4 only associate Multilevel Device).
[Note:] Press and hold on key for 2 seconds before step 3) would terminal add device procedure.
„
Remove Z ‐ Wave Device from key ‐ fob
1) Press and hold both and key together for 2 seconds until LED indicator light on, release all key;
2) Press and hold key for 2 seconds until LED indicator flash quickly (1 second on, 1 second off), key ‐ fob starts remove
device processing;
3) Refer to device manual, trigger the device which is going to included start network add/remove mode;
4) If key ‐ fob detects any device started network add/remove mode, it implement remove device procedure and LED
indicator light on for 3 seconds after exclusion successful; If key ‐ fob has not detects any device in 15 seconds, exit remove
device process and LED indicator goes off.
[Note:] Key ‐ fob erase the excluded device from all association control groups (#2~#4) automatically after remove an exist device.
[Note:] Press and hold on key for 2 seconds before step 3) would terminal remove device procedure.
„
Copy Z ‐ Wave Device in key ‐ fob to a new controller
1) Press and hold both and key together for 2 seconds until LED indicator light on, release all key;
2) Press and hold key for 2 seconds until LED indicator intermittently flash (light on 2 times in 3 second), key ‐ fob
starts copy controller network processing;
3) Refer to controller manual, trigger the controller which is going to copied starts network learn mode;