Waste electrical products should not be disposed of with household waste. Please recycle where
facilities exist. Check with your Local Authority or retailer for recycling advice.
Live Voltages may be present in this unit even when turned of or when completely disconnected.
For your safety, always switch off the supply before changing lightbulbs, or cleaning.
This system contains non-replaceable parts and cannot be serviced. If damage occurs the part should be scrapped.
Saxby Lighting Ltd. BH23 3PE
Care and Cleaning
Recycling Advice
Safety Information
The shade must be replaced immediately should the shade become cracked or damaged. This
Replace Cracked
Shade
Iss. 3 13082015
Do not use solvents or abrasive cleaners as these could damage the finish.
In normal circumstances, stainless steel is very resistant to corrosion. It does however require maintenance to
preserve the high quality appearance. Wash the product with warm soapy water, removing all surface deposits. Rinse
with clear water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation. This is normally caused by tiny iron particles left behind
after the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over.
However if the product is subject to extreme environmental conditions such as marine locations, industrial
pollution and acid rain these maintenance procedures should be carried out around four times a year. For severe
corrosion, non-abrasive cream cleaners or proprietary stainless steel cleaners should be used to remove the
corrosion. Wash and dry as detailed above. Then with a soft cloth soaked with a protective oil, wipe all over.
Glass parts - Remove and wash in warm water or just use a damp cloth. Do not use abrasive materials as these
will damage the finish. Glass parts - Remove and wash in warm water or just use a damp cloth. Do not use
abrasive materials as these will damage the finish.
Do not clean the units with a pressure washer.
Fitting / Replacing Bulbs
Commissioning
13. Fit the product over the fixing bolts, re-fit the plastic washers (B) and then the dome nuts (A). Use a suitable
spanner to securely tighten the product to the mounting surface.
14. Replace fuse or circuit breaker and switch on. Your light is now ready for use.
When changing a bulb, always switch off at the mains and allow the bulb to cool
before handling. Dispose of used bulbs carefully. Use a soft cloth to handle bulbs, avoid
directly touching the bulbs as this will shorten their life. Do not exceed the wattage stated
or use a different shape bulb from that indicated on the fitting.
Bulb type - 35W GU10
1. Unscrew the bezel
2. Remove the old bulb by turning anti-clockwise.
3. Insert new bulb.
4. Replace the bezel ensuring that it is tightly secured.
GU10 240V
35W MAX
