Installation
Wiring
Existing fittings must be completely removed before
installation of a new product. Before removing the existing
fitting, carefully note the position of each set of wires.
1. Using base plate as a template, mark the fixing holes
onto the mounting surface.
2. Drill holes to the necessary size and depth - taking care
not to damage any concealed pipes or wiring below the
mounting surface.
3. This product comes complete with expanding bolt type
fixings (C) which are suitable for use on most surfaces,
however alternative fixings may be required.
4. Push the fixing bolts into the mounting holes.
A
D
B
C
Having correctly identified the wiring from your existing
light fitting, pull the wire through the hole and connect
to the connection block inside the product in the
following way:
5.
Pull terminal block (D) from inside of tube.
6.
Unscrew the 4 screws which attach the black box
to the spacing strip. Open the black box and pull
out the terminal block.
7.
Connect Live input wire to brown wire on product
(or terminal on terminal block marked ‘L’).
8.
Connect Neutral input wire to blue wire on
product (or terminal on terminal block marked
‘N’).
9.
Connect Input Earth wire (Green/yellow) to Earth
wire on fitting,
10. Check that you have correctly identified the supply
wires, the connections are tight and that no loose
strands have been left out of the connection block.
11. Push terminal block back into the black box.
Re-attach the black box to the mounting bracket.
12. Push the terminal block up into of the tube.
Cable wired to product
Terminal block case
Supply cable
Spacing strip
LIVE
wires
NEUTRAL
wires
EARTH
wire
EARTH
wire
You have correctly identified the wires.
The connections are tight.
No loose strands have been left out of the connection block.
Check That