17
RT-FS/RT-PHFS OWNER’S MANUAL
2
3
Thread ten hex nuts (1.2) all the way
onto ten flat head Phillips screws (1.3).
Place the router table (1.1) upside
down on a flat surface and thread
the flat head Phillips screws (1.2) into
the threaded holes around the insert
opening in the table until they extend
about ¼” below the table’s top surface.
These screws will support and level the
router lift relative to the table top. The
2 holes in the center of the short ends
of the opening (indicated by the red
arrows) do not receive leveling screws;
they will be used later to attach the
router lift to the router table.
Assembling the 32" x 24" Cast Iron Router Table
Requires:
32" x 24" Cast Iron Router Table and Hardware
Phillips
Screwdriver
1
The router table is shipped with a
coating of oil to prevent the cast iron
from rusting. Remove the protective
covering and wipe the oil off the top of
the table with a soft, clean cloth.
x10
1.1
1.2
1.2
1.3
1.1
