18
1.
Use only mild soap and water on a soft cloth to clean the control.
Care Tips for Control
2.
Do not use abrasive cleansers
N
Step 1
Step 2
Do not oversize or undersize the hole.
Step 3
Step 4
67 mm
25 mm
25 mm
A
B
C
D
Wall
Wall
Do not route the control or temperature sensor wiring inside conduit
together with power lines or close to hot water or steam piping. Doing so may result in
an inoperative or hazardous installation. Do not alter or modify the control. Doing so may
result in an inoperative or hazardous installation.
Determine the desired installation location of the control.
The SAWO control is designed to be installed inside or
outside the steam room as a matter of personal preference.
The control cable length is 7.5 m. Insure that the control
and/or steam generator are located accordingly.
Turn on power to the steam generator and test the control
to verify correct connections. Test per the instructions.
Proceed with installation and verification of proper control
function.
Route the control cable to the steam generator.
Connect the connector to the steam generator.
!
CAUTION
Installation Instructions
SAWO Controls
Installation, Operation & Maintenance Manual
IMPORTANT:
Turn power to the steam generator OFF
before installing the control. Failure to turn the power
off will result in an inoperable control.
IMPORTANT:
Do not strain, staple pinch or otherwise
damage the control cable. Route cable as required to
permit replacement.
NOTE:
The connector is keyed.
IMPORTANT NOTE:
Turn power to the steam generator OFF before installing the control.
Failure to turn the power off will result in an inoperable control.
19
Wall
Wing nuts
Holder plate
Wall
Keypad
Adhesive tape
Step 7
Insure the
mounting surface
is and dry as required
for good adhesion.
Apply silicone into
the hole in the wall
as required to create
a moisture seal.
Hold the
control and press
the control against
the wall until the
adhesive sticks and
holds firmly as shown.
Step 6
Run a bead of
silicone (provided)
as shown to the
C shaped groove as
shown.
Step 5
Remove & discard
peel-off paper to
expose adhesive
liner as shown.
IMPORTANT:
Do not apply
excessive amounts
of silicone.
Do not apply silicone
to any other parts of
the control including
the adhesive gasket.
