SUOMI
6
standby Mode
During the standby-mode the water in the steam generator tank is kept hot. This mini-
mizes the time to produce steam when generator goes to on-mode next time.
Standby-mode can be activated by any of the following methods when the unit is in on-
mode:
1. Short press “Standby” button
2. Short press “Power” button
3. When session time expires.
In standby-mode text “Standby” is displayed altering with the remaining standby time.
To change remaining time press “up” or “down” arrow buttons. If the time is changed
during the first 5 minutes after the activation of standby-mode, the time will be saved as
a new default standby time.
To activate on-mode again short press the “standby” button.
To go off-mode:
1. Press “Power” button for more than 3 seconds.
2. Press “Standby” button for more than 3 seconds to activate autodrain process, after
which the unit goes automatically off-mode. (If autodrain feature is not available the
unit will go off-mode)
3. Wait until remaining standby time expires and autodrain process (if available) com-
pletes.
auto drain Mode
The auto drain feature automatically drains the water system after every use. The tank
is flushed and will remain empty until the steam generator is used again.
After the Standby time runs out, control unit automatically goes to Autodrain mode.
When the drain cycle is activated, the generator’s tank will be filled first. The water
inside the tank will be cooled down, so the valve can be opened, as the water is not
boiling hot anymore.
The draining process will take about 10 minutes.
User can cancel auto drain process whenever the water level in the tank is at normal or
below normal level by pressing “power” button for more than 3 seconds.
To start Auto Drain in “On” mode press “Power” or “Standby” button followed by a long
press (more than 3 seconds) of “Standby” button.
Temperature / Timer
The temperature/timer button can be used to switch between the temperature and
session time.
When the steam generator is switched on, the set temperature at the steam room is
displayed. It can be changed by pressing up and down buttons.
If the temperature/timer button is pressed, the remaining session time will be displayed.
It can be changed by pressing up and down buttons. The session time will be saved as
the default session time if it was changed within the first 5 mins from the beginning of
“On” mode.
If the temperature/timer button is pressed again, the unit will return displaying the set
temperature. In addition, if no buttons are pressed for 10 seconds, the set temperature
of the steam room will be displayed.
