15
1. Cut a sample 'X' moulding at least 12 inches long.
2. Measure the X distance of the cut board, and
press [-D-] [X].
3. Enter the actual X length of the sample piece and press [Start] to return to the ready screen.
Calibrate Miter Cut Y Distance
1. Cut a sample 'Y' moulding at least 12 inches long.
2. Measure the Y distance of the cut board, and
press [-D-] [Y].
3. Enter the actual Y length of the sample piece and press [Start] to return to the ready screen.
Calibrate Miter Cut Z Distance
1. Cut a sample 'Z' moulding at least 12 inches long.
2. Measure the Z distance of the cut board, and press
[-D-] [Z].
3. Enter the actual Z length of the sample piece and press [Start] to return to the ready screen.
Calibrate Increment Distance
1. Press [-D-] [<±>].
2. Enter the length of the desired increment and press [Start] to return to the ready screen.
Straight Cutting
SawGear has been set up on a chop saw or miter saw and has been homed and is now ready
to run.
SawGear can be used in Foot Mode or in Metric Mode.
Basic Operation
Consists of two simple steps:
1.Enter a dimension and hit [Start].
2.When SawGear moves to position, make your cut(s).
45° Miter Cutting
All miters will be 45° cuts. See also Custom Miter Cutting.
SawGear can be used in Foot Mode or in Metric Mode.
These buttons, located along the top of the SawGear control,
are used to set up your machine for miter cuts.
19
