14 |
P a g e
TT
Sheet Clamp
TT
- Is used as an extra hand to hold material in place so you don't
have to. It is especially handy with cutting long narrow pieces
on the material rollers or long pieces on the mid fence.
a. Make sure the dust pan & magnet on sheet clamp is free of
dust & debris.
b. Place the magnetic side of the sheet clamp in the center of the
dust pan with the hinge to the top. (It will self center so it will
not interfere with the blade’s cutting position)
c. Adjust the height placement by sliding the entire clamp up or
down on the dust pan.
d. To clamp your material, lift the front arm of the clamp. A top
magnet will keep it in the open position for you. Slide your
material underneath the front arm, then lower the arm to
secure your material.
e. WARNING!!!! You must remove the sheet clamp before rip
cutting or using the router insert. Do not attempt to rotate your
saw to a horizontal position when the clamp is in the dust pan.
TT
Laser Pointer
TT
- Allows you to easily see where you are cutting before you
make the cut.
a. This accessory is pre-installed. Adjust laser line position
before using.
b. Make sure your unit is square. (See installation instructions)
c. Pull back your blade guard, and set a truly squared sheet
against the saw blade. Turn on laser.
d. Loosen the laser assembly on the aluminum extrusion until the
laser’s line is even with the material. Bolts are located
underneath the laser’s bracket.
e.
To adjust the angle of the laser’s line roll back rubber guarding
on the laser to expose the plastic wheel. Use this wheel to
make minor adjustments.
f. You may also adjust the angel of the entire laser bracket by
loosening nut and swinging laser housing, then re-tightening
nut.
g. Remove the material and use a permanent marker to draw a
line where the laser’s light is on the silver dustpan for easy re
-
alignment.
h. Change the batteries by removing the tiny screw and sliding
back battery cover.
i.
To Use
: Make sure the laser lines up with the mark you made
on the dust pan. Then slide your material into place, align
your measurement with the laser line and make your cut.
REMEMBER to turn off power after each use.
TT
Flip Stops
TT
- Saves time when cutting standard lengths of material. Two
adjustable stops are included.
c.
e.
On/off
switch
f.
h.
Hinge
Front
arm
Summary of Contents for 2064
Page 1: ......
