18 |
P a g e
TT
Wall Mounting System
TT
- Used to permanently attach your unit to a wall.
a.
You will need to provide two 2x4 boards, each 4 feet long. All
mounting brackets, screws and a nut driver are included in this
accessory package. If you have a folding stand on your unit you
will need to remove it.
b.
When deciding where to wall mount your unit, consider your
work space, not the unit’s width. (Example: If you typically rip
cut 4x8 sheets, you will need at least 8.5 feet of working space
on each side of the cutting blade, for a total of 17 feet of
working space.)
c.
Using the ¼ X ¾ self tapping screws, attach the wall mounting
brackets to the vertical square tubes just below the top &
bottom horizontal tubes as illustrated.
d.
Measure the height of the TOP horizontal bar and add 1 inch to
this measurement.
e.
Measure the height of the BOTTOM horizontal bar and add 1 inch
to this measurement.
f.
Once you have decided where to mount your machine, find and
mark the studs.
g.
Using the measurements of step
d
, mark the height placement
on each of the wall studs. Attach one 2x4 across the studs,
using four(4) of the ½ x 4” self tapping screws, as illustrated.
h.
Using the measurements of step
g
, mark the height placement
on each of the wall studs. Attach one 2x4 across the studs,
using four(4) of the ½ x 4” self tapping screws, as illustrated.
i.
Position your unit with the wall mounting brackets against the
2x4’s on the wall. Use the ¼ x 1½ self tapping screws to
permanently attach each bracket to the 2x4’s.
j.
Once completed, pull on the unit to ensure it is secure and will
not come off the wall.
k.
WARNING! This unit is heavy and could cause injury if
improperly mounted. Always check the security of the machine
prior to use.
Self taping screw
d.
e.
C.
Wall studs
g
h
Summary of Contents for 2064
Page 1: ......
