OPERATION
DELSAR
®
VICTIM SIMULATOR
6
7000-01-011 R07
www.savox.com
Once the code is selected in the main unit,
the exact same code must be selected in
the remote control transmitter. To set the
transmitter code, open the transmitter
housing by inserting a coin into the rear of
the housing near the key chain slot. Pry the
housing open and locate the code circuit
wire traces on the circuit board. Matching
the exact same code that was set in the
Victim Simulator, scratch the trace to select
the proper code sequence. When the circuit
trace is scratched, it is the same as setting it
to “off”. Reassemble the transmitter housing
and test the remote control to verify correct
operation.
Use a small screwdriver to slide the switch
to set the code. Any combination may be
used. When reinstalling the lid, align the lid
so that the rocker control switch is directly
over the hammer shaft and make sure that
all the wires are clear of pinch points.
