SETUP
DELSAR
®
VICTIM SIMULATOR
3
7000-01-011 R07
www.savox.com
VICTIM SIMULATOR SETUP
Battery Installation
The Delsar
®
Victim Simulator is shipped with the batteries removed and the
remote control antenna detached. Both must be installed to operate the unit.
To install the batteries, remove the battery compartment door which is located on
the bottom of the housing between the rubber feet. To open the compartment,
remove the two screws with thumb and forefinger.
Install the batteries, observing the correct polarity. Be careful not to pull the
battery wires more than one inch (25 mm) from the battery housing.
Install the batteries, observing the correct
polarity. Be careful not to pull the battery
wires more than one inch (25 mm) from
the battery housing.
NOTE:
Overextending the wire may cause
damage to the wires. The unit will run
on one battery, however run time will
be reduced to less than two hours. With
the batteries installed, carefully nest the
battery into each compartment and push
the wires back into the upper housing
to prevent them from getting pinched.
Reinstall the battery cover plate.
