2
SAFETY AND GENERAL INFORMATION
•
Failure to comply with the enclosed may result in injury or blindness.
•
WARNING: Risk of Ultraviolet Rays. Flying Particles. Wear Safety Goggles (User and
Bystanders).
•
Materials which come into contact with the wearer’s skin could possibly cause allergic
reactions to susceptible individuals.
•
Scratched or damaged oculars (lenses) should be replaced.
•
This is not a Paintball mask! It is a welding helmet.
• Toughened mineral filter oculars shall only be used in conjunction with a suitable backing
ocular.
•
Read and understand all instructions before using.
•
Be sure that the dark shade of the lens in the welding helmet is the correct shade number
for your application.
•
These helmets and lenses are not suitable for “overhead” welding applications, laser
welding, or laser cutting applications.
•
Welding helmets are designed to protect the eyes and face from sparks, spatter, and
harmful radiation under normal welding conditions.
•
This helmet will not protect against explosive devices or corrosive liquids. Machine guards
or eye splash protection must be used when these hazards are present.
•
Impact resistant, primary eye protection, spectacles or goggles that meet current ANSI
specifications must be worn at all times when using this welding helmet.
•
Avoid work positions that could expose unprotected areas of the body to spark, spatter,
direct and/or reflect radiation.
•
Check for light tightness before each use. Before each use, check that the protection plates
are clean and that no dirt is covering the sensors on the front of the lens.
•
Inspect all operating parts before each use for signs of wear or damage. Any scratched,
cracked, or pitted parts should be replaced immediately.
• Do not make any modifications to either the welding lens or helmet, other than those
specified in this manual. Do not use any replacement parts other than those specified in
this manual. Unauthorized modifications and replacement parts will void the warranty and
expose the user to the risk of personal injury.
•
If this lens does not darken when striking arc, stop welding immediately and contact
representative.
•
Do not immerse this lens in water if this model is not waterproof.
•
Do not use any solvent s on any lens or helmet components.
•
The recommended operating pressure is -10°C – 55°C (14°F – 131°F). Do not use this
device beyond these temperature limits.
•
Failure to follow these warnings and/or failure to follow all of the operating instructions
could result in severe personal injury.
NOTICE:
For your SAFETY - PLEASE read and follow all of these instructions exactly. If you have problems
understanding these instructions or have questions, please call 1-866-783-3223.
Caution! Read and follow these instructions EXACTLY for care and cleaning of the lenses.
Summary
The automatic welding mask is a new generation product for labor protection. New and high
science technologies such as LCD, optoelectronics detection, solar power, microelectronics, etc.
are integrated into it. The automatic welding mask can not only efficiently protect the operator’s
eyes from injuries caused by arc, but also can make both hands free and allow the user to strike
arc accurately. Therefore, the quality of products and work efficiency may be raised considerably.
It may be used for various activities such as welding, cutting, spraying and arc gouging, etc.
WARNING
!
Summary of Contents for Get'r Done Series
Page 8: ...8 NOTES ...
