Savant Standalone Energy Monitor Deployment Guide
Copyright 2020 Savant Systems, Inc
009-1928-01 | 200828
8 of 24
3. Installation
3.1. Flat Surface
SEM-2015
Mounts to a wall or similar surface. Mount chassis in a place that is
dry, well ventilated, and out of direct sunlight.
The SEM-2015 comes with the mounting plate installed.
1.
Set the SEM-2015 onto the wall where it will be mounted.
The SEM-2015 can be positioned with ports facing vertically
or horizontally. Level the unit and mark the positions of the
mounting plate holes on the wall.
2. If there is a sub-wall to screw into, screw unit to wall using
appropriate screws. If no sub-wall is available, wall anchors can
be used.
SEM-1024
Mounts to a wall or similar surface using the included chassis-
mounted side brackets and supplied M3 x 8mm flat head screws.
Mount chassis in a place that is dry, well ventilated, and out of direct
sunlight.
1.
Remove side brackets and M3 x 8mm screws from shipping box.
2. Align the holes in the bracket with threaded holes on the two
short sides of the SEM-1024 energy monitor.
3. Screw bracket to chassis using the supplied M3 x 8mm screws.
Do not over-tighten.
4. Set the SEM-1024 onto the wall where it will be mounted.
The SEM-1024 can be positioned with ports facing vertically
or horizontally. Level the unit and mark the positions of the
mounting holes on the wall.
5. If there is a sub-wall to screw into, screw unit to wall using
appropriate screws. If no sub-wall is available, wall anchors can
be used.
