SD-BA-e-2121
7
This function is used for measurements where unwanted "pre-peaks" occur which are
below the peak value (Fp) being searched for. The adjustable limit value (Fo) prevents
the measuring instrument from storing the "pre-peaks".
Minimum limit function is only possible in "Peak Mode
Setting the minimum limit value function see SET menu under "Keys
4.8 Storage of peak values and calculation of average values from up to 10
values
- Storage of the peak values in the measuring device
- Activation of the "AUTO PEAK function" via the PEAK key
- Now all peak values are automatically transferred to the device memory. (From the
11th value onwards, the oldest entry is automatically overwritten)
- Individual peak values can be recalled using the arrow keys (shown in the upper
display segment)
- Press the MEMORY key to call up the average value (visible in the upper display
segment)
- Deleting the memory contents by pressing the
▼ key in AVERAGE mode
4.9 Reset key
This is located on the right side of the housing.
It is used to restart the unit after an operating error. Memory values and settings are
deleted.
5
Thread of the fine adjustment screw
This applies to the following SD's: SD 50, 100, 200, 300, 500
The thread of the fine adjustment screw is a DIN M6 thread, according to this DIN is
also the pitch.
It corresponds to approx. 1mm per turn of the knurled nut.
6
Printout to printer or PC
Below are two photographs:
The picture below shows the closed compartment for the printer's paper roll, which is
located on the side of the spring tester. A piece of paper with the printed measurement
results can be seen from the outside. It leaves the paper roll compartment through a
