17
Maintenance
3. Release the 4 clips from the underside, allowing you to remove the
bottom plate.
2. Turn the Powerhead upside down and remove the small screw from
the centre of the Powerhead.
DO NOT OPEN
4. To remove the rotating brush, lift the right side of the brush first
from the Powerhead, followed by the left side, where the belt loops
around the end cap. Slide the old belt off the drive shaft and then
off the end cap. If the belt is broken, remove all the broken pieces.
5. Place the new belt over the drive shaft first and then around the end
cap. Make sure the text on the belt is outward facing, then insert
the rotating brush back in to the Powerhead. Replace the bottom
plate and insert the screw.
