SATO DR308e, Quick Manual

Page: 26 / 116

26
English
Basic Specifications of DR308e
Model DR308e
Print method Direct thermal and thermal transfer
Head density 8 dots/mm (203 dpi)
Printable area 80 mm (width)
×
181 mm (pitch) or less
2 to 5 inches/second
(However, restrictions may apply depending on the type of print layout, paper, and carbon ribbon.)
Paper Use a roll media specified by SATO.
Paper thickness
Tag stock: 160 to 280 µ m
Label paper: 70 to 265
µ
m
Standard Tag stock Width: 32 to 80 mm
Pitch: 25 to 181 mm
Label paper Width: 29 to 77 mm (32 to 80 mm)
Pitch: 16 to 178 mm (19 to 181mm)
Tear-off Label paper Width: 29 to 77 mm (32 to 80 mm)
Pitch: 22 to 178 mm (25 to 181mm)
Dispense Label paper Width: 29 to 77 mm (32 to 80 mm)
Pitch: 22 to 178 mm (25 to 181mm)
Cutter Tag stock Width: 32 to 80 mm
Pitch: 25 to 181 mm
Label paper Width: 29 to 77 mm (32 to 80 mm)
Pitch: 22 to 178 mm (25 to 181mm)
* The figures within () indicate the backing liner size.
* Restrictions may apply depending on the number of sheets issued or the size and type of paper.
However, size restrictions may apply depending on the conditions of use.
Permissible outer diameter : Ø250 mm maximum (Roll media supply spindle: When installed on upper spindle)
: Ø140 mm maximum (Roll media supply spindle: When installed on lower spindle)
Paper core inner diameter : Ø1.5 to Ø4 inches (conditions apply depending on the paper type)
Ribbon width:
84 mm maximum
Ribbon length: 300 mm roll maximum (Conditions apply depending on the ribbon type)
Winding direction: Reverse winding
Take-up method: Paper core take-up
Carbon ribbon Use a carbon ribbon specified by SATO.
Operation modes
Standard: Continuous, tear-off
Optional: Cutter, dispense
Communication interface (1 slot)
External connector (for optional devices)
RS-232C D-sub 9-pin type (for simple input device (Keypad) only)
(1) RS-232C interface board
(2) IEEE1284 interface board
(3) LAN interface board
(4) USB interface board (Full speed)
(1) Cutter unit
(2) Simple stacker
(3) External take-up unit
(4) Dispenser unit
(5) Simple input device (Keypad)
(6) Calendar IC
(7) External take-up device RW350
Control panel
LCD: Character LCD (8 digits × 2 lines), backlit
Keys: LINE and FEED
(1) I-mark sensor level adjustment
(2) Gap sensor level adjustment
Level adjustment
(3) Jump hole sensor level adjustment
(4) Print density adjustment
(5) Printing position adjustment
(6) Cutter, dispenser, tear-off stop position adjustment
(1) I-mark sensor (reflective type)
(2) Gap sensor (pass type)
(3) Jump hole sensor
Detection sensors (4) Ribbon-end sensor
(5) Head-open sensor
(6) Dispenser sensor (when the dispenser unit is installed)
(7) Cutter sensor (when the cutter unit is installed)
Print speed
Permissible paper roll and
tag stock outer diameter
Ribbon size and type
Media size
Interface board
Optional communication
interface boards
Options