SATO KEIRYOKI 6427-00, Instruction Manual

Page: 16 / 20

15
(1) While the unit is off, connect the RS-232C connection cable to the RS-232C port on the back of the unit.
(2) Insert the 9-pin connector of the RS-232C connection cable into the serial port (9 pin) on the computer.
(3) Press the key to turn on the unit. The unit outputs the measurement data in the measurement
mode.
● Communication conditions
Communication standard of computer
Communication speed : 9600bps
Data bit : 8
Stop bit : 1
Parity check : non
● Example of the communication protocol
Ex. pH : pH12.00
mV : -129.9mV
Temperature : 25.0°C
Time : at 12:30:30 on January 1, 2015
Communication protocol
$pH:mV:TpHE1
P12:00 : m-129.9mV : T25.0C @2015-1-1 12:30:30 dc cr If
Analog output
The unit outputs the electromotive force of the pH sensor in real time while in the measurement mode.
By connecting the unit to your device, the appropriate analysis will be performed.
Note: The unit does not output the electromotive force while it is calibrating, displaying recorded data or in
the setting mode.
● Connecting the cable
A 2.5-mm monaural plug is necessary for connection. Prepare the following items.
Dimensions: 2.5 (Dia.) × 11 (L) mm
Wiring: See the figure on the right.
(1) While the unit is off, insert the plug into the ANALOG port on the back of the unit.
(2) Press the key to turn on the unit. The sensor electromotive force is output in the measurement
mode.
│
pH value
│
Temp.
│
year, month, day time
│
checksum
│
mV value
Positive (+) side
Negative (−) side