Satfi Control Box, Installation Manual

Page: 7 / 12

2. If surface of the vehicle is
curved
, left and right side
feet
of the antenna are not
in contact
with the
roof
surface. In such cases
wedges/
spacers in
the
proper width
should be used to fill the gaps.
3. 4 pieces of 3.9x32 stainless screws and M5 washers that are
included
with the antenna
.
Using the
screws with washer
s should be
screwed loosely
into
the side
feet
of the
antenna leaving
sufficient
space. The silicon is applied between the side
feet
and
the base and to around the side plates and the bottom of the equipment. After that
half tightened screws are tightened firmly without leaving space and the antenna
fastened. Finally, the side plates are covered with silicon without covering the
screws.