SATEL VERSA
Plus
7
LED keypad
The state
ones
llu
of z
is i strated by LEDs designated by numbers. The steady-on LEDs
ED means that the
cursor is situated there. Use the
indicate which zones are inhibited or isolated. The blinking (flashing) L
and
keys to move the cursor. The cursor may
ed over the LEDs corresponding to the zones which can be bypassed or
only be mov
unbypassed. Press any digit-bearing key to change the LED status:
LED ON – the zone is to be inhibited,
LED OFF – the zone is to be unbypassed.
Press
to quit the function. The zones will be inhibited/unbypassed.
Zone isolating
The isolated zone will remain bypassed until it is unbypassed by the user.
Enter the user menu and press in turn
. Information on the bypassed
d. How it will be presented depends on the type of keypad.
d the proce ure a
zones will be displaye
LCD keypad
The way of indicating the zone state an
d
re identical to those used for
inhibiting the zones, but pressing any number key will change the displayed symbol to one of
the following symbols:
– the zone is to be isolated,
– the zone is to be unbypassed.
LED keypad
The way of indicating the zone status and the procedure are identical to those used for zone
in
g the event log
hibiting.
1.8.3 Viewin
The function is only available in the LCD keypad.
Enter the user menu and press in turn
. The last event that occurred in the
ent description includes the time of its occurrence, its name
the partition in which the event took place, the zone which
ed
rs automatically a few seconds after
system will be displayed. The ev
and additional information, e.g.
the event, etc. The additional information appea
caus
the event is displayed. Press
or
f r the
o
additional information to be displayed
sooner. To scroll through the event log, use the
and
keys.
1.8.4 Checking the troubles / system state
When the
LED is blinking, you can check what caused this signaling. Enter the user
menu and press in turn
. The LCD
ad pre
ts inform
keyp
sen
ation on the display.
To scroll through the list, use the
and
keys. In the LED keypad, information on
escription of the LEDs, please refer to the
troubles will be presented by means of LEDs (for d
LED keypad user manual).
2. Operating the alarm system by means of keyfob
The alarm system can be operated by means of keyfobs, if the 433 MHz keyfobs receiver
expansion module (INT-RX-S / INT-RX), 433 MHz wireless system controller (VERSA-MCU)
00 / ACU-250) is
or ABAX wireless system controller (ACU-120 / ACU-270 / ACU-1
connected to the control panel.
