SATEL VERSA
Plus
5
1.3.4 Arming without delay
hen arming the system
W
using one of the above mentioned methods, press and hold down
the arming mode selection key (
,
or
) for about 3 seconds. The system will
e. the delayed zones will act as instant ones (without any
become armed without delay, i.
exit/entry delay time).
In the day or night arming mode, the entry delay countdown may run, if the control
panel is so configured by the installer.
Arming with proximity card
VERSA-LCDR / VERSA-LCDM-WRL
n use one of the following methods to
1.3.5
You ca
arm the system (consult with the installer which
full mode.
method is to be used):
– bring the card close to the keys and move it away,
– bring the card close to the keys and hold it there for about 3 seconds.
The partitions to which you have access will be armed in
1.4 Disarming and alarm clearing
1.4.1 Disarming and alarm clearing w
Enter the code and then press the
ithout partition selection
key. Disarming / alarm clearing will take place in the
ring
sarmed and/or where alarm is to be cleared (press one
partitions to which you have access.
1.4.2 Disarming and alarm clea
in selected partition
1. Indicate partition which is to be di
of the keys:
- partition 1;
- partition 2).
2. Press the
key. Backlight of the keys will start blinking, which indicates that the code
must be entered.
3. Enter the code.
4. Press the
or
key.
1.4.3 Disarming and alarm clearing with a proximity card
VERSA-LCDR /
VERSA-LCDM-WRL
Bring the card close to the keys and move it away. Disarming / alarm clearing will take plac
in the partitions to which you have access.
e
1.5 Quick control of outputs
Quick activation of output
Press the key to which the controllabl
.
e output is assigned, and then
Quick deactivation of output
Press the key to which the controllable output is assigned, and then
.
1.6 Turning the CHIME on /off
The CHIME is five short sounds by means of which the keypad
nfo
will i
rm you e.g. that
tem is disarmed. The installer defines which zones of
and whether it can be turned on/off by the users.
a door / window is open, when the sys
the alarm system can trigger the CHIME
Press and hold down
for about 3 seconds to turn on or off the CHIME signaling.
