22
PERFECTA-T
SATEL
Entry delay in Day Arm
[Entry del. day]
– if this option is enabled, there is entry delay when
the partition is armed in day mode. If this option is disabled, there is no entry delay when
the partition is armed in day mode.
6. Zones
A zone can be assigned to one or two partitions. If the zone is assigned to two partitions, it
can be armed when both partitions are armed or one of them only.
The system supports the following zones:
hardwired
– on the control panel PCB and in expanders. The number of available
hardwired zones is determined by the control panel during the identification procedure.
wireless
– in the PERFECTA-T 32-WRL control panel, after adding wireless detectors. The
number of available wireless zones depends on the number of wireless detectors
registered in the system.
virtual
– zones which do not physically exist, but are controlled by means of keyfobs.
6.1 Zone parameters and options
Fig. 13.
“Zones” tab.
Name
[38.Names]
– individual name of zone (up to 16 characters).
Wiring type
[31.EOL]
– type of detector and the method of its connection:
No detector
– no detector is connected to the zone,
NC
– the zone supports a detector of NC (normally closed) type,
NO
– the zone supports a detector of NO (normally open) type,
EOL
– the zone supports a detector of NO or NC type with EOL resistor in the circuit,
2EOL/NO
– the zone supports a detector of NO type with two EOL resistors in the circuit,
2EOL/NC
– the zone supports a detector of NC type with two EOL resistors in the circuit,
Roller
– the zone supports a roller shutter detector,
Vibration
– the zone supports a vibration detector (also NC type detector).
