Satel INT-TSG, Installer Manual

Page: 8 / 28

6 INT-TSG SATEL
5.1 Keypad connected to INTEGRA / INTEGRA Plus control panel
The identification function can be run by using:

LCD keypad:

S
ERVICE MODE

S
TRUCTURE

H
ARDWARE

I
DENTIFICATION

LCD
KEYPADS
ID
. How to enter the service mode, refer to section on programming keypad address by
means of the service function (p. 4).

D
LOAD
X program:  “Structure” window  “Hardware” tab  “Keypads” item  “Keypads
identification” button.
5.2 Keypad connected to VERSA / VERSA Plus control panel
To run the identification function for keypads and expanders you can use:

keypad:  S
ERVICE MODE
 2. H
ARDWARE
 1. K
PDS
. &
EXPS
.  1. I
DENTIFICAT
. How to enter
the service mode, refer to the section on programming keypad address by means of the
service function (p. 5).

D
LOAD
X program:  “Versa – Structure” window  “Hardware” tab  “Expanders” branch
 “Identification” button.
6. microSD memory card
On the microSD memory card:

you can put the additional macro command icons;

you can put photos which will be used for the slide show;

you should put the file with a new version of the keypad firmware, if the firmware is to be
updated.
The keypad supports the microSD and microSDHC memory cards.
The microSD memory card should be purchased separately.
Inserting and removing the memory card requires opening of the keypad enclosure, so
if the alarm system is working, remember to start the service mode.
6.1 Inserting the microSD card
Fig. 3. Installing the microSD memory card.