2 INT-KSG
SATEL
4. Screw down the wires connecting the keypad to the control panel keypad bus to the DTM,
CKM and COM terminals (see Fig. 3). The wires should be run in one cable.
5. Connect the wires to the terminals of additional zones, if any detectors are to be
connected to them (the detectors are to be connected in the same way as to the control
panel onboard zones).
6. Connect power supply to the keypad (ter12V and COM). The power supply can
be provided from the control panel mainboard, an expander with power supply unit
installed in the system, or from an additional power supply unit.
7. Place the front panel onto the catches, snap close the housing and insert the fastening
screw.
Fig. 1. Opening the housing.
