TOEPC72060013
M3 x 6
M5
ø6 mm
M5
Phillips #2
TOEP C720600 13C Remote Keypad Mounting Kit Instruction Manual
9
This installation kit is compatible with keypad models JVOP-KPLxxxxxxx.
Please refer to the Installation Manual packaged with the drive or keypad when you install this option.
6 ea.
ø6 (0.24)
mm (in)
75 (3.0)
minimum
clearance
Side View
100 (3.9)
131 (5.2)
165 (6.5)
minimum
clearance
117 ±1
(4.61 ±0.04)
180 (7.1)
minimum
clearance
127 ±1
(5 ±0.04)
72 (2.8)
72 (2.8)
5
Cut the Opening
1
Procedure for Installation of Remote Keypad Mounting Kit for UL Type 1, Type 12, Type 3R, and IP55 Enclosures
2
Compatible Products
3
Collect the Required Tools and Equipment
4
Make Sure the Kit Will Fit in the Desired Location
6
Snap-fit the Keypad (Not Included) into the Keypad Kit Subassembly
Use the measurements above or the template in
A
to cut the opening and drill or punch 6 each ø6 holes on
the customer-supplied enclosure.
You can also use the provided M3 x 6 flat head screws and tighten to 0.49 to 0.73 N•m (4.3 to 6.4 in•lb) for additional security.
Use the provided M5 flange nuts and tighten the screws in the order shown below with initial torque.
Gradually increase the torque to 2 to 2.5 N•m (17.1 to 22.1 in•lb) to evenly compress the gasket.
Select the customer-supplied keypad cable length best suited for the enclosure size.
Plug one end of the cable into the female connector on the back side of the keypad. Plug the other end of the
cable into the female connector on the front of the drive.
The location of the connector is different for different drive models.
Electrical Shock Hazard. Do not connect or disconnect wiring while the power is on. Failure to comply will
result in death or serious injury. Before servicing, disconnect all power to the equipment. The internal capacitor remains
charged even after the power supply is turned off. The charge indicator LED will extinguish when the DC bus voltage is
below 50 Vdc. To prevent electric shock, wait for at least the time specified on the warning label, once all indicators are
OFF, measure for unsafe voltages to confirm the drive is safe prior to servicing. Failure to comply will result in death or
serious injury.
DANGER
Measure the printed dimensions before you drill the screw holes. Moisture can cause the template scale to
change.
NOTICE
7
Attach the Keypad Kit Subassembly to the Enclosure
8
Select the Keypad Cable
