4 ASP-100
SATEL
4. Installation and start-up
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
Be particularly careful during installation and replacement of the battery. The
manufacturer is not liable for the consequences of incorrect installation of the battery.
The siren must be installed on the wall, high above the floor, at a hard to access location, so as to
minimize the risk of tampering. Make sure that some free space is left above the siren (at least 2.5
cm). Otherwise, it will be impossible to replace the cover.
1. Remove the cover locking screws.
2. Lift up the enclosure cover by approx. 60º and remove it (see Fig. 3).
3. Install the battery and add the siren to the wireless system (see the ACU-120 / ACU-270 controller
manual or installer manuals for VERSA / VERSA Plus control panels). The sticker with serial
number which shall be entered when registering the siren in the system can be found on the
electronics board.
4. Replace the siren cover.
5. Fasten the siren temporarily at the place of its future installation.
6. Check the level of signal received from the siren by the ACU-120 / ACU-270 controller. If the
signal level is lower than 40%, select another place for installation. Sometimes, it is sufficient to
shift the device ten or twenty centimeters to obtain a considerable improvement in the signal
quality.
7. Remove the siren cover.
8. Disconnect the battery.
9. Move aside the catches holding the electronics module and remove it.
10. Place the enclosure base on the wall and mark the location of mounting holes (see Fig. 2). Be
sure to take into account the tamper mounting hole.
11. Drill the holes for wall plugs (screw anchors).
12. Secure the enclosure base to the wall with wall plugs (screw anchors) and screws. Remember
about the tamper mounting hole. The wall plugs (screw anchors) and screws delivered with the
siren are intended for brick, concrete and similar mounting surfaces. For other surfaces (e.g.
drywall, wood, styrofoam), use other wall plugs (screw anchors), as required.
13. Secure the electronics module in the enclosure base.
14. Connect the battery.
15. Replace the siren cover and fasten it with screws.
16. Configure the siren (set the signaling duration, type of acoustic signaling, etc.). For detailed
information on how to configure the siren, refer to the controller manual.
5. Battery replacement
The used batteries must not be discarded, but should be disposed of in accordance
with the existing rules for environment protection.
1. Start the service mode in the control panel.
2. After the leftmost LED on the siren starts blinking every 3 seconds, you can open the siren
enclosure.
3. Disconnect and remove the spent battery.
4. Secure the new battery with a cable tie.
5. Press and hold down the tamper switch.
6. Connect the new battery.
7. When the leftmost LED on the siren starts blinking every second, release the tamper switch.
SATEL sp. z o.o. • ul. Budowlanych 66 • 80-298 Gda
ń
sk • POLAND
tel. + 48 58 320 94 00
www.satel.eu
