6 AOD-200
SATEL
Angle bracket mounting
1. Attach extra tamper switch:
– screw the holder to the tamper switch (Fig. 7-I),
– screw the tamper unit to the enclosure base (Fig. 7-III).
Figure 7 shows mounting the tamper switch in one of two available positions. The
place of tamper switch installing depends on the way of angle bracket mounting. If the
tamper switch is to be installed in the other position, place tamper switch holder on the
other side.
2. Prepare openings in the bracket for screws.
3. Using wall plugs (screw anchors) and screws, fasten the bracket to the wall.
4. Run the tamper switch wires through the hole made in the enclosure base and connect
them to the TMP terminals.
5. Using screws, fasten the enclosure base to the bracket (Fig. 9).
Ball bracket mounting
1. Attach extra tamper switch:
– screw the holder to the tamper switch (Fig. 8-I),
– put the unit making the surface bigger on the tamper switch (Fig. 8-I),
– screw the tamper unit to the ball bracket (Fig. 8-III).
2. Run the cable through the opening in the handle of the bracket.
