SATEL AOD-200
3
alarm – the red LED is ON for 2 seconds.
Supervision of detector signal path
In case of signal path failure, the detector sends information about alarm during each
transmission (constant violation).
Battery status control
When the battery voltage is below 2.75 V, information about low battery is sent during each
transmission.
3. Electronics module
TMP terminals – tamper input (NC).
pins to enable /disable the tamper input. If
no additional tamper switch is connected
to the TMP terminals, jumper should be
placed across the pins.
CR123A lithium battery.
microwave sensor.
green LED.
red LED.
yellow LED.
The LEDs are working for 2 minutes
after battery is inserted, as well as in
the test mode (see: “Test mode”).
During detector startup, all LEDs are
blinking alternately for about 40
seconds.
dusk sensor.
dual element pyrosensor.
Do not touch
the pyroelectric sensor, so as not to
soil it.
tamper switch activated by cover removal.
fixing screw holes.
On the other side of the electronic board is a tamper switch activated by removing the
detector from the wall.
When mounting the detector on the angle or ball bracket, it is recommended to install
additional tamper switch.
4. Installation
There is a danger of battery explosion when using a different battery than
recommended by the manufacturer, or handling the battery improperly.
