III.9
EN
Operating instructions SATAjet 4000-110/-120 (DIGITAL)
Operating instructions SATAjet 4000-110/-120 (DIGITAL)
Warning! Attention!
•
After cleaning, the spray gun, the material passages, the air
cap including thread as well as the gravity flow cup have to
be blown dry with clean compressed air!*
* otherwise risk of corrosion
** otherwise damage of the electronic components of DIGITAL
spray guns
Notice!
•
Check spray pattern after cleaning the nozzle set!
• Further tips concerning cleaning can be found at www.sata.com/TV.
9. Maintenance
Warning! Attention!
•
Prior to maintenance, disconnect spray gun from the compressed air
circuit!
•
Disassemble and install components very carefully! Exclusively use
included special tools!
9.1. Replacing the Nozzle Set
[7-1], [7-2], [7-3], [7-4], [7-5]
and [7-6]
Every SATA nozzle set consists of "paint needle"
[7-1]
, "air cap"
[7-2]
and "fluid tip"
[7-3]
and has been hand-adjusted to provide a perfect
spray pattern. Therefore, always exchange the complete nozzle set. After
installation, please adjust material flow according to chapter 7.2.
9.2. Replacing the Air Distribution Ring
Steps: [7-1],
[7-2], [7-3], [8-1], [8-2] [8-3], [7-4], [7-5] und [7-6]
Attention!
•
Remove air distribution ring with SATA extraction tool only.
•
Do not apply force to avoid damage of sealing surfaces.
EN-Content-BAL-SATAjet 4000 -110 -120.indd 9
29.10.2012 13:43:42
Summary of Contents for SATAjet 4000 Series
