SATA AE5736, User Manual

Page: 14 / 18

中文
EN
AE5736/AE5737
14
disconnection of the gas circuit parts during the use of the equipment, which may cause operation accidents and
injury accidents.
- Before starting the equipment, ensure that the operator has worn gloves, masks, goggles, protective earmuffs, long-
sleeved overalls and trousers, which can prevent the operator from being injured in the process of operation.
- In case of sudden failure in the operation of machinery and equipment, the power supply should be cut off
immediately.
- After shutting down the machine, all kinds of auxiliary tools should be cleaned and put in place for later use.
- Non-professionals are strictly prohibited from dismantling the internal structure of the cleaning machine, including
but not limited to electrical parts, electronic parts, gas circuit parts, mechanical structure, etc.
Chapter
Ⅳ
Maintenance Instruction
- Please read this manual carefully before installation and use to give full play to the best performance of the machine
and maintain safety.
- Without professional training personnel, do not disassemble or clean any parts in the machine, to avoid damage to the
electrical equipment, such as electric shock, smoke, fire and other accidents.
- It is recommended to test the working performance of the air switch with leakage protection once a month.
- After the completion of each operation of the dry ice cleaning machine, the intake hose and cleaning hose should be
disassembled and put into the chassis after finishing; The above hoses shall not be placed on the ground at will, and
shall be prevented from being crushed or impacted to damage and leak air.
- The nozzle is a tight component. The nozzle will be deformed due to collision or improper placement, which will
seriously affect the machine's efficiency.
Chapter
Ⅴ
Common Fault Description
- When the power switch is turned on, the power indicator is not on. Please check whether the external power supply of
the equipment is normal and whether the connection is correct. Then open the chassis plate to check whether the air
switch with leakage protection is in normal position.
- There is no dry ice output during normal startup and cleaning. Please check the amount of dry ice in the dry ice
bucket and check whether the dry ice in the dry ice bucket is agglomerated due to condensation of water vapor. The
agglomerated dry ice can be continued to be used after separation.
- In some areas, because the air humidity is too large, there will be no ice phenomenon after a long time operation
of the equipment, which is a normal phenomenon. At this point, take out the dry ice in the dry ice bucket, and the
equipment can be resumed after standing for 20 minutes.